Address : 10351 Xylon Ave. N., Suite 130
Brooklyn Park, MN 55445
Call Us : 651-408-1044
Mail Us :

CT Reflow Clam


Product Number: catht-ref-clam-089

The CT Reflow Clam machine differs from CT Reflow Chamber machine because of its ability to be programmed to skip over various parts of a catheter assembly, therefore removing heat from designated parts of the catheter.


The CT Reflow Clam uses a split die design that opens and closes around the needed parts where heat is necessary. This is especially advantageous should a catheter assembly have sensitive sensors or other materials in it where heat should not be applied. Additional features can be added to the Clam Shell Chamber including: Operator safety precautions, Ease conversion to CT STRETCHER, Loading elevators can be added for operators to load assemblies at lower levels.


  • 5" inches Chamber length (STD size)
  • Chambers intersawabble - hot or cold
  • 2 pin per screw
  • Per changover (less than 10 mins)
  • Low maintenance required
  • Crated wieght 900-1000 lbs (Std)
  • Clam shell 1200 lbs. 3 phase
  • 208-240 VAC 30 AMP
  • Clam minimum air pressure - 90 psi on clam
  • HMI interface
  • Easy setup